How to flash Android phones
How to flash Android phones 1.Download and extract firmware on your computer. 2.Download and Extract Odin v3.10.7 or any new versio...
How to flash Android phones
2.Download and Extract Odin v3.10.7 or any new version.
3.Open Odin v3.10.7.
4.Now, restart your Phone in Download Mode (by pressing Home + Power + Volume Down buttons together).
5.Now, Connect your Samsung device to the computer and wait until you get a blue sign in Odin.
6.Now, Add the firmware file in Odin using AP / PDA button.
7.Now, Make sure re-partition is NOT ticked before starting the flashing process
8.Finally, Click on the start button, sit back and wait few minutes to get the flashing process completed.
How to flash Samsung Stock Rom using Odin
Download and install Samsung USB Driver on your computer. In case you have already installed the Samsung USB Driver on your computer then Skip this step.
>Download (Stock ROM compatible with your device or if you have already downloaded the firmware then ignore downloading it again) and extract it on your computer. After extracting you will be able to see these kind of files.
Power Off your Samsung Device.
Now, you have to boot into Download mode. To boot into Download Mode: Press and Hold Volume Down Key, Home Key and Power Key. When phone vibrates Leave the Power Key but Keep holding the Volume Down Key and Home key. You will boot into the Download Mode.
In the Download mode you will be able to see a Warning Yellow Triangle Sign. In this situation you have to press the Volume up key to continue.
Download and extract Odin on your computer. After extracting you will be able to see the following files:
Now, <strong>Open Odin3 and connect your phone to the computer.
Once you have connected the phone to the computer, Odin will automatically recognize the device and show “Added” message at the lower-left panel.
Once your device is detected by Odin, click on the “PDA” button and select the tar.md5 file that you have extracted in Step #2.
Now, click on the “Start” button in Odin to begin the Flashing process.
Once you see, the Green Pass Message then remove the USB cable from the device (during this process, your device will restart automatically).
Your Samsung Device will now stuck at boot (boot loop). Now, You have to boot into Stock Recovery Mode, To Enable Stock Recovery mode: Press and Hold Volume UP key, Home Key, Power Key. When phone vibrates Leave the Power Key but Keep holding the Volume UP Key and Home key. You will boot into the Recovery Mode.
In Recovery Mode,Wipe Data/factory reset.
Once Cache Data is cleared, Select Restart Phone Now from the recovery menu.
Now, your Samsung Device will restart without any issue with the Stock Rom you have downloaded.